PA6 GF30 for Automotive Low-Voltage Electrical Components

2026-11-15 
clicks155 clicks
PA6 GF30 Application: 12V/24V automotive low-voltage systems (connector bases, terminal blocks, relay housings, fuse brackets, sensor bases, wire harness clips). Standard grade is heat-stabilized HB. Flame retardant / high CTI grades are available upon modification.
PA6 GF30 Advantages for Low-Voltage Electrical PartsTPzANIXT NYLON China Manufacturer
1.Excellent flowability: good filling for thin-wall, complex cavities and multi-terminal connector bases.TPzANIXT NYLON China Manufacturer
2.Good resistance to oil, coolant and automotive chemicals, resistant to cracking when exposed to grease and antifreeze in engine bays.TPzANIXT NYLON China Manufacturer
3.High rigidity and creep resistance: stable terminal clamping force, less loosening under long-term vibration.TPzANIXT NYLON China Manufacturer
4.Cost-effective and stable supply; available in black for laser marking, natural color and custom colors. Can be modified for toughening, heat stabilization, halogen-free V0 or red phosphorus flame retardancy.TPzANIXT NYLON China Manufacturer
5.Heat-stabilized formulation (standard for automotive grades): controllable strength retention after long-term thermal aging at 100~120℃, compliant with automotive aging specifications.TPzANIXT NYLON China Manufacturer
TPzANIXT NYLON China Manufacturer
PA6 GF30 Recommended  ApplicationsTPzANIXT NYLON China Manufacturer
1.Low-voltage connectors, switch bases and harness brackets in dry cabin areas.TPzANIXT NYLON China Manufacturer
2.Terminal blocks and sensor housings inside engine bays with minimal condensation and short heat exposure.TPzANIXT NYLON China Manufacturer
3.Cost-sensitive, complex thin-wall low-voltage electrical structural parts with long flow paths.TPzANIXT NYLON China Manufacturer
TPzANIXT NYLON China Manufacturer
PA6 GF30 Typical Properties (Heat-stabilized grade for automotive low-voltage electrical parts, ISO standard)
Item Value Remarks
Density 1.36 g/cm³  
Tensile Strength 160~180 MPa (dry)  
Flexural Modulus 8800~10000 MPa High rigidity & good creep resistance, stable terminal retention force
HDT @1.8MPa 200~210 ℃ Suitable for short-term high temperature in engine compartment
Saturated Water Absorption 2.2~2.8% Key weakness: modulus and insulation drop after moisture uptake
Volume Resistivity ≥10¹³ Ω·cm (dry); 10¹⁰~10¹¹ Ω·cm after moisture absorption Insulation decreases significantly when wet
CTI 425~500 V (base HB grade) Flame-retardant modified version can reach 550~600 V, meets GWIT 750/850℃ glow-wire requirements
Dielectric Strength 28~32 kV/mm (dry)  
Molding Shrinkage MD:0.3~0.5% / TD:0.8~1.2% Strong anisotropy, thin-wall parts prone to warpage

* The application cases shown may not fully match your target products. Please inform us of your specific requirements, and we will assist you in material selection.

Next : Back to List
clicks